Safety

1. Always wear a seat belt in a vehicle

2. Never exceed the speed limit or use a mobile phone without hands-free when driving

3. Never drive or work under the influence of drugs or alcohol

4. Always work under a valid work permit when required

5. Always use safety gear when working at heights

6. Always verify the isolation of energy sources before starting the work

7. Never bypass or break safety critical equipment

8. Never walk or stand close to working

To be allowed to work in the mill area, you must have completed:

• an occupational safety card
• first-aid fire-fighting training (minimum requirement)
• Stora Enso's general safety induction
• Imatra Mills' local safety induction
• department-specific safety briefing

You can complete Stora Enso's general safety induction and Imatra Mills' local safety induction in the following address:

http://elearning.fi/storaenso/turvainfo/

Password: sesafety

The general induction takes around an hour to complete. The local induction takes around 10 min and it must be completed in one go for it to be saved. The completed induction is valid for two years.

The department-specific safety briefing takes place at the mill.

Always when working at the mill:

• helmet
• protective goggles (sealed model if required), also when moving around outside
• protective gloves
• hearing protection
• protective footwear
• high visibility clothing EN 471-2 (when moving around outside or in warehouse)
• long-sleeved work clothing

Protective clothing according to the situation.

When handling chemicals, chemical pipelines and chemical equipment, a full protective mask must be worn and the instructions of the safety data sheet must be adhered to.

Basic work clothes in maintenance, service and installation work are a work jacket and/or long- sleeved work shirt and trousers, bib-and-brace overall combination outfit or coverall. The protective clothing must be worn so that the outfit covers both the upper and lower body, neck, arms and legs.

When using a personnel lifting device, fall protection must be worn and a safety rope must be attached in order to prevent falling.

Full face mask with ABEK-P3 filter for gases.

At least an FFP3 class mask is required at the effluent treatment plant.

A welding helmet for welding and ALWAYS a fresh air breathing apparatus in stainless steel welding.

Concentration meter in all confined spaces, also in other work if required.

NB! For work in the power plant's liquor line area, the work team must have a hydrogen sulphide concentration meter (H2S) and in the odorous gas boiler area (HK1, HK2, HK3/IMAGE project) a sulphur dioxide concentration meter (SO2).

Accident

• The supplier must have sufficient first aid equipment and trained personnel at the site
• If necessary, there are first aid equipment in the garages and control rooms
• At the start of the work, you must familiarize yourself with the area's emergency showers and eye rinsing points

Fire

In addition to minimum fire extinguishing equipment and protective equipment, persons carrying out hot work must be equipped with at least one 25-39 mm / 20 m fire hose with a 2" claw connector and a matching nozzle.

Gas hazard

• The supplier brings the required personal protective equipment and concentration meters to the worksite
• When work starts at the worksite, workers must familiarise themselves with the area's fire and emergency instructions and the location of the defibrillators in the mill area
• Review how to call for help and the locations of the gas shelters beforehand. In emergencies, always call 112.

Always inform work supervisor in case of accidents and safety observations

Emergency number: 112

When placing the call, state:

• who you are
• what has happened
• where it happened
• is anyone in danger

Answer any questions.

Do not end the call before you are told to do so.

Arrange for someone to show the way.